Or is this not the way of going about integrating smoke detector alerts? How do I get your smoke detector code into the “ST_Anything_Doors_Windows_EthernetW5100.ino” sketch for upload?Ī.Are the wires in my panel, with resistors attached, my contact sensors? What are the wires without resistors, typically?. Here are my nooby questions (hopefully attached images will help shed some light on my setup)… So a few basic questions…I’m sure you already went over these… and I apologize if I’ve missed the answer to my questions somewhere along this thread or in your readmes… I have an Arduino Mega 2560 and an Ethernet Shield W5100 (purchased these 2 after reading your thread and seemed like the best fit – I like staying wired whenever possible)… my alarm panel has door/window contact sensors (maybe 8-10), 1 motion sensor, and 2 smoke detectors (have to check if the smoke detectors are battery powered or not, but I do NOT think so)… I’ve successfully compiled and uploaded your “ST_Anything_Doors_Windows_EthernetW5100.ino” sketch (editing all mandatory lines you commented on) and the IP I set to my Arduino Mega 2560 instantly starting to ping once uploaded!!! So that was a great feeling!!! Dan, this work you have done is exactly what I’ve been looking for so thank you!!!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |